-
September 22nd, 2001, 05:22 PM
#1
Inactive Member
I recently installed an AEM FPR to lower my static fuel pressure, because my car was running sluggish.
So I lowered my idle pressure as low as 32 and it still goes way rich on the a/f ratio gauge and I get a code 45. Any suggestions on what I should try? Should I try the stock fuel pump? or a Cartech FMU maybe? My mods are below.
00 Civic SI
JRSC 6psi
JR BTC
JR fuel pump
JR Map Controller
Short Ram Intake
AEM FPR
boost gauge
a/f ratio gauge
b& m fuel pressure gauge
------------------
[This message has been edited by SinisterSI (edited September 22, 2001).]
-
September 23rd, 2001, 02:04 PM
#2
Inactive Member
-
September 23rd, 2001, 02:19 PM
#3
Inactive Member
Try the Cartech.... I don't know which brand of A/F gauge you have, but remember that most A/F gauges suck at reading rich or lean conditions, so the more green the better in my opinion. What is your timing set at and what is your BTC set at?
------------------
95 Hybrid w/SC'd JDM B16
-
September 23rd, 2001, 02:36 PM
#4
Inactive Member
I have an autometer a/f gauge. My timing is set at 19, BTC at 2 clicks from min.
------------------
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks